Logic Analyzer Perspective

The following figure shows the Debug perspective for the Logic Analyzer.

Figure 1. Debug Perspective GUI - Logic Analyzer
Select Bitsteam Connect Debugger Disconnect Debugger
Start Programming Add Net Remove Net
Stop Programming Select Waveform File
To perform debugging using the Logic Analyzer:
  1. Select the bitstream and program the FPGA.
  2. Connect the Debugger.
  3. Add triggers. If you turned on Capture Control in the Debug Wizard, you can adjust the capture mode in the Capture Setup tab. Set the # Trigger option if you want the trigger to occur after n occurances (default is 1).
  4. Click Run to run the code. The Debugger waits for the trigger conditions you set and then captures data.
    Click Run Immediate to begin capturing data immediately.
  5. The Core status and Capture status areas show the progress.
  6. The Console shows messages.
  7. Click the Select Waveform File button to choose a waveform file.