Set Up a USB-to-UART Module

The Titanium Ti60 F225 development board has a USB-to-UART converter connected to the

Ti60’s GPIOL_01 and GPIOL_02 pins. To use the UART, connect a USB cable to the FTDI USB connector on the development board and to your computer.

Note: The board has an FTDI chip to bridge communication from the USB connector. FTDI interface 2 on Ti60 communicates with the on-board UART. You do not need to install a driver for this interface because when you connect the Titanium Ti60 F225 development board to your computer, Windows automatically installs a driver for it.