Hardware Set Up for Titanium Ti60 F225 Development Board

The following figure shows the hardware setup steps for Titanium Ti60 F225 Development Board example design. If you have not already done so, attach standoffs to the board.

Figure 1. Titanium Ti60 F225 Development Board Hardware Setup
  1. Connect a USB-C cable to the board and to your computer.
  2. Attach the Ethernet Connector Daughter Card to header P1 of the development board.
  3. Connect an Ethernet cable to the RJ-45 receptacle on the Ethernet Connector Daughter Card and to your computer.
  4. Leave the board jumper settings to default. Refer to the development kit User Guide for information about the default jumper settings.
  5. Connect the 12 V power supply to the board connector from a power source.
  6. Turn on the board.
Note: Ensure that you install the driver for the correct interface. Refer to the Titanium Ti60 F225 Development Kit User Guide for information about installing the drivers.