When you check your design, the Interface Designer applies design rules to your
configuration settings. The following tables show some of the error messages you may
encounter and explains how to fix them.
seu_rule_start
(error)
| Message |
Empty SEU Start Detection pin name found Invalid SEU Start
Detection pin name found |
| To fix |
Enter a valid start pin name. |
seu_rule_interval
(error)
| Message |
Invalid wait interval <#> microsec |
| To fix |
Change the wait interval to one that is in range. Allowable values are
0 - 1677721. |
seu_rule_empty_pins
(error)
| Message |
Empty pin names found: <pin_type> |
| To fix |
Enter a valid pin name. |
seu_rule_invalid_pins
(error)
| Message |
Invalid pin names found: <pin names> |
| To fix |
Enter a valid pin name. |
seu_rule_error
(error)
| Message |
Empty Error Status pin name found Invalid Error Status pin name
found |
| To fix |
Enter a valid error pin name. |
seu_rule_param
(error)
| Message |
Invalid parameters configuration: <feature list> |
| To fix |
One of the parameters you set was incorrect. Review any other errors
for details. |
seu_rule_es_device (error)
| Message |
SEU Detection is not supported in ES device |
| To fix |
You get this error if you try to enable SEU for the Ti60ES. SEU is not
supported in this FPGA. |