Package/Interface Support Matrix

Some interfaces are only available in certain packages. The following table describes which interfaces are supported in specific FPGA/package combinations for the Efinity® software. Refer to the data sheet for package-dependent resources.

Note: New package support is often added in patches. Refer to the Efinity Release Notes in the Support Center for the latest patch support.

Table 1. Supported Titanium Interface/Package Combinations
Package	Ti35	Ti60	Ti90, Ti120, Ti180	Ti85, Ti135	Ti165, Ti240, Ti375
W64
F100
F100S3F2
F225 F256
G400
J361, J484, M484¹
L484
N484
C529
G529
N676
N1156

Titanium Family Legend:

Oscillator	PLL	SSC PLL²	Fractional PLL	LVDS	PCIe, Ethernet 1XGMII, PMA Direct, Ethernet SGMII
MIPI RX or TX Lane	MIPI D-PHY Controller	DDR DRAM Controller	SPI Flash and HyperRAM	Quad-Core RISC-V

Table 2. Supported Topaz Interface/Package Combinations
Package	Tz50	Tz110, Tz170
F100, F225, F256
G400
J361, J484

Topaz Family Legend:

Oscillator	PLL	SSC PLL³	Fractional PLL	LVDS
MIPI RX or TX Lane	MIPI D-PHY Controller	DDR DRAM Controller

Table 3. Supported Trion Interface/Package Combinations
Package	T4	T8	T13	T20	T35	T55	T85	T120
F49
W80
F81
Q100
Q144
F169
F256
F324
F400
F484
F576

Trion Family Legend:

Oscillator

PLL

LVDS

MIPI CSI-2 Controller

DDR DRAM Controller

SPI Flash

¹ Available for Ti180 only.

² The SSC PLL block and MIPI D-PHY TX Controller block cannot be used at the same time. Refer to About the Titanium Spread-Spectrum Clocking PLL Interface for more information.

³ The SSC PLL block and MIPI D-PHY TX Controller block cannot be used at the same time. Refer to About the Titanium Spread-Spectrum Clocking PLL Interface for more information.